Biometric reader with built-in battery
Biofinger-I is the most advanced biometric device for time attendance purposes with high quality optical sensor which can read even dirty & oily fingerprints.
This biometric reader has built-in backup battery which can supply power to standby the device for 23 hours. This model is most suitable where there is a frequent power failure and construction job sites where there is limited or no power supply.
The battery will get auto recharge once the reader connected to the power supply.
Usually construction workers are fetched by lorry from their dormitory to their job sites. This reader can be placed in a lorry and connected to the lorry power charger. While alighting at the job site, the workers can do the clocking to the machine for attendance.
This model biometric reader comes with reliable optical sensor and strong Intel 32bit X-scale CPU. It has double-engine biometric identification arithmetic technology which supports 360 degree rotation identification.
Up to 3 fingers per employee can be registered. While doing attendance the employee can use any on the finger to do clocking.
It takes about one second to verify the employee finger and the Date & time has been registered into the device.
If a particular employee all the finger damaged, then that employee can use PIN number for attendance purpose.
|Sensor||Reliable Optical sensor|
|Data Transfer method||TCPIP Network (RJ 45) / USB Thumb drive|
|Capacity||3000 fingerprint Templates|
|Storage Memory||100,00 verification records|
|Primary Verification method||Biometric|
|Secondary Verification method (optional)||Proximity car / PIN number|
|Verification Message||Audio message & displays the employee name|
|Screen||Color 3” TFT screen with GUI interface|
|Verification Mode||1:1, 1:N|
|False Acceptance Rate (FAR)||<=0.0001%|
|False Rejection Rate (FRR)||0.01%|
|Operating Humidity||20% – 80%|
|Size||190(L) x 135 (H) x 65 (D) mm|
|Power Supply||12V DC 1.5A|